Need help confirming fitment for your vehicle?
Before placing your order, please send clear photos of your vehicle's front wheel, rear wheel and brake-lever connector. ZOOM can help you verify the correct brake setup and mounting position.
What's Inside
This Package
Package contents may vary depending on the selected option, such as front brake, rear brake, or front and rear set.
- 01 ZOOM H‑Series hydraulic brake caliper version selected
- 02 Matching brake lever with power‑off sensor
- 03 Hydraulic brake hose for the selected front or rear setup
- 04 Matching brake pads, pre‑installed in the caliper
- 05 Required mounting hardware for the selected kit
- 06 For front and rear sets: left and right brake levers, short and long hoses, and matching front/rear calipers
Your Speed Increased.
Your Brakes Should Too.
More powerful motors and heavier bikes demand better braking control. Upgrade from traditional cable systems to hydraulic performance.
Mechanical Brake
Traditional cable braking systems struggle when speed, weight and heat increase.
- ✕ Cable Stretch Over Time
- ✕ Requires More Hand Force
- ✕ Performance Drops Under Heat
- ✕ Frequent Cable Adjustment
ZOOM Hydraulic Brake
Engineered hydraulic power delivers smoother control and consistent braking.
- ✓ Instant Hydraulic Response
- ✓ Stronger Brake Modulation
- ✓ Stable Performance In Heat
- ✓ Less Maintenance Required
Vertical Front Fork Installation
If your front fork has vertically aligned mounting holes, use the mount adapter to install the brake caliper.
Install the mount adapter
Attach the adapter to the vertical mounting holes on the fork.
Mount the caliper
Position the caliper on the adapter and align it with the rotor.
Tighten and check
Tighten the bolts with a 5 mm Allen key and make sure the rotor runs freely without rubbing.
Standard: 160mm (Customizable)
Range: 140mm - 203mm (Recommended for E-bike heavy-load heat dissipation).
Specs: 1.8-2.3mm thickness, 6-bolt mount.
Adapter: Includes IS/PM universal adapter.
Note: Ensure frame/fork clearance for 180mm. Avoid oversized rotors to prevent overheating.
Front: ~1350mm
Rear: 2200mm (Designed for larger E-bike frames).
Adjustment: Support cuttable lengths with new olive/banjo fittings.
Note: Pre-filled with oil. Requires professional bleeding if cut; check routing to avoid motor/frame interference.
Type: Mineral Oil ONLY.
Capacity: 20-50ml for service/bleeding.
Warning: NO DOT fluid. Do not mix brands.
Note: Immediately clean any leaks with alcohol to protect E-bike electronics and paint surfaces.
Adjustment: Align 4-piston calipers via bolts; use built-in reach/free-stroke screws.
Bleeding: Crucial for E-bike performance; use standard bleed kit + funnel.
Maintenance: Inspect pads (<1mm) and lines every 300-800km. Keep rotor/pads free of oil.
